Power Saving Control Box:
1. The Control Box automatically powers down into ‘Standby’ mode after approximately 10 seconds of inactivity.
2. During Standby mode, the Control Box only consumes 0.1 watt of power.
How to set the Active Touch display height for the first time:
1. Upon first time install of the Active Touch controller or after a Power Cycle, the text will blink “SELECT”, “HEIGHT”.
2. Lift up or press down on the Controller to select the correct lowest starting height.
3. Wait for 2 seconds until the light guide fills. When all three bars are full, the height selection is saved.
How to reset the Active Touch display height:
1. On the Controller, press 1, 2, 1, 2. The display will begin blinking “SELECT”, “HEIGHT”.
2. Lift up or press down on the Controller to select the correct lowest starting height.
3. Wait for 2 seconds until the light guide fills. When all three bars are full, the height selection is saved.
How to power cycle (initialize) the Control Box:
In the unlikely event that an error occurs, and the desk is unresponsive:
1. Unplug the desk Power Cord from the outlet.
2. Wait at least 10 seconds.
3. Reconnect power to the desk.
How to test Lifting Columns:
Lifting Column can be operated independently.
1. Obtain a Control Box that is known to work. Be sure the Control Box is unplugged, or plugged in but in Standby mode.
2. Connect the Low-Voltage Cable of the Lifting Column to the known-good Control Box. Connect only to Port/Channel 1 (farthest from the Power Cable).
3. Obtain a Controller that is known to work, and connect it to the Control Box. Tip: Verify that the Control Box software is current when using the Active Touch controller.
4. If the Control Box is unplugged from the wall outlet, plug the Power Cable back in.
5. With the system hot, operate the Lifting Column.
A. Can the Lifting Column be operated through its full range of motion?
B. Does the Lifting Column appear to function normally?